How to Install Premium Bamboo Woven Wood Shades

1. 1

   Check that you have all the parts for your shade's width.

2. 2

   For wallboard or plaster, use anchors designed for hollow walls (not included).

3. 3

   For concrete, stone or brick, use a masonry drill bit and masonry anchors (not included).

• 18" to 42" wide: 2 brackets, 4 screws
• 42 1/2" to 84" wide: 3 brackets, 6 screws
• 84 1/2" to 96" wide: 4 brackets, 8 screws

1. 1

   Plan the end brackets 1" to 2" from each end of the headrail; line up any middle brackets with the pre-drilled holes in the headrail.

2. 2

   Hold the shade in place and mark the bracket locations with a pencil, using a level to keep them straight.

3. 3

   Pre-drill the mounting holes and screw the brackets to the mounting surface.

4. 4

   Remove the wing nuts, hold the shade so the bracket screw posts go through the slots in the headrail, and screw the wing nuts back on tightly.

5. 5

   Make sure the shade is level.

1. 1

   Plan the end brackets about 1" from each end of the headrail; line up any middle brackets with the pre-drilled holes in the headrail.

2. 2

   Measure 1" in from each side of the window frame and mark the bracket locations with a pencil.

3. 3

   Pre-drill the mounting holes and screw the brackets to the top of the window frame.

4. 4

   Remove the wing nuts, hold the shade so the bracket screw posts go through the slots in the headrail, and screw the wing nuts back on tightly.

5. 5

   Make sure the shade is level.

Clutch-control shades have a continuous cord loop that must always be secured with the included cord tensioner. Never operate the shade without it.

1. 1

   Choose a flat spot where the cord or bead chain will be taut but not stretched: the window sill or inside of the frame for an inside mount, or the outside of the frame or the wall for an outside mount.

2. 2

   Make sure the cord isn't twisted or crossed.

3. 3

   Mark through the holes in the tensioner with a pencil and drill pilot holes.

4. 4

   Screw the tensioner in place, fully seated so the spring is pushed in and the cord passes smoothly through the guide.