How to Install Super Value Cordless Light Filtering Top Down Bottom Up Single Cellular Shades

1. 1

   Check that the parts in your package match the parts list.

2. 2

   Plan your bracket positions. Placement is the same for inside and outside mounts.

• Up to 38" wide: 2 brackets
• 38-1/8" to 72" wide: 3 brackets
• Over 72-1/8" wide: 4 brackets

1. 1

   Before mounting, add any extra depth needed to clear window cranks or handles.

2. 2

   Screw each installation bracket to the top of the window opening through its top two holes.

3. 3

   Make sure all brackets are level and aligned. Shim them if needed.

• Minimum mounting depth: 3/4"
• Depth for a fully recessed shade: 2-1/8"

1. 1

   Screw each installation bracket to the wall or molding through its two back holes.

2. 2

   Use the same holes on every bracket so the shade projects evenly from the surface.

3. 3

   Make sure all brackets are level and aligned. Shim them if needed.

• Minimum flat mounting surface height: 1-1/2"

1. 1

   With the front of the shade facing you, tilt the headrail slightly back to angle its front inside lip into the brackets.

2. 2

   Push the headrail back and up until it snaps into place.

3. 3

   Make sure no fabric is pinched between the brackets and the headrail.

1. 1

   Decide where the handles go: one handle at the center of the rail for shades 48" wide or less; two handles evenly spaced, as far apart as is comfortable, for shades over 48" wide.

2. 2

   Gently lift the fabric out of the way.

3. 3

   Hook the handle onto the underside of the bottom rail and swing it up until the top snaps securely in place.

4. 4

   On a top-down/bottom-up shade, attach a handle to the middle rail the same way.

• With the shade fully lowered, the handle sits about 1/2" above the window sill so it is easy to grab.

1. 1

   Hold the handle at the center of the bottom rail so the shade moves level. On wider shades with 2 handles, use both.

2. 2

   Lower the shade by gently pulling down to the position you want.

3. 3

   Raise the shade by gently pushing up to the position you want.

Raise and lower the shade several times. If the bottom rail or the middle rail (top-down/bottom-up) is not level, adjust it.

1. 1

   Bottom rail: hold it with both hands and gently pull down on the high side. Stop when the rail is level.

2. 2

   Middle rail: hold it with both hands and gently push down on the high side. Stop when the rail is level.

1. 1

   Shade won't snap into the brackets: check that the brackets are aligned and level.

2. 2

   Shade is hard to raise or lower: an inside-mount shade can't be forced into a tight opening, so check there is clearance between the ends of the shade and the window frame. Also check the brackets are level, any hold-downs are released, and the fabric isn't caught.

3. 3

   Shade raises unevenly or the bottom rail is uneven: measure the window diagonals to check it is square, level the brackets, and adjust the rail.